![]() That way, your cover material comes out square to your swimming pool’s shallow end. So, as your safety pool cover ropes stretch from the weight on top, you’ll need to consider rope adjustments. Your automatic safety pool cover depends on ropes, a motor, and a pulley system. This measure helps clear off debris and leaves from the material and conditions your material with UVA or UVB. You’ll need to clean your automatic pool cover material every year. If you have taken good care of your safety swimming pool cover for more than ten years, you may spend $6,000 above the amount used to install the pool safety cover. Using these two products will help extend the life service of your automatic safety covers by slowing down the dry rotting process. So, you’ll need a vinyl material cleaner alongside a UVA protectant. Even so, with time, this material will rot away. Usually, automatic pool safety covers come from vinyl and can withstand sun rays. The three top problems include cleaning and maintenance, power loss, and animals during winter. Even so, automatic pool covers come with their share of problems. Most customers opt for automatic pool covers for improved chemical and energy savings and safety features. It helps to research the pros and cons of your swimming pool safety covers before making your purchases. While you might be satisfied with your safety covers, some are still unsure about the available market options. ![]() Note : The pre-assembled hardware on the axis takes into account the motors dimensions.With the summer season ending, the time is ripe for you to start thinking about how you’ll cover your swimming pool for the upcoming winter months. If the pool itself is not straight, this will also cause the shutter covers slats to be out of line. If this is the case, unrolling will equally cause friction with pool wall with the shutter cover. This causes the layers of slats to be out of line. Incorrect positioning will provoke the incorrect rolling of the cover. The straps should be fitted in their respective supports which can be adjusted in relation to the shutter cover. The first module of the slats is equipped with weaved nylon straps 50mm wide. Once the shutter cover has been assembled, it should be fixed to the rolling axis. ![]() To simplify assembly, the slats should be placed, by module, on water.įixation of the shutter cover on the axis This module should be positioned at the extremity of the shutter cover which is opposite to the rolling axis. One of the modules is equipped with obliged security straps. The other slats are delivered in modules of 3 or 6 elements. The first module of the shutter is delivered with fixation straps attached to the axis. The slats must be stocked in the shade, with an air temperature lower than 40°c. The assembly of the shutter can only be undertaken if there is water in the pool. If this option is used it must be installed in a position where the pool is visible during each opening and closing unit.ĭuring the installation, if the key control cable terminals are inverted and the shutters action does not correspond to the open and close position on the box, cross the cable terminals "F and O" in the control box.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |